Loading…
DIN-rail mounting plate for the Mean Well RS-25 - sized from its own 2-hole bottom pattern (M3) with safety-limited counterbored screws, and a clip-slot interface that snaps onto a TS35 rail via a printable clip (or frame slots for a 2020 extrusion). Fits every RS-25 voltage variant (3.3/5/12/15/24/48V).
Mounts an enclosed supply - Mean Well LRS-50 to RSP-500, the slim UHP-200 and UHP-350, and the LDO LCP300 - on its own bottom-hole pattern: snap onto DIN rail, bolt to 2020 extrusion, fit end brackets, or hang a UHP upright on a 1515 extrusion. Screw length is checked against the PSU depth limit.
Open the full Power Supply Mount configurator →Where a proven community part already exists, it travels in the download with its license and is credited here rather than re-generated.
More on how these parts are made: the About page.
License: CC BY-NC 4.0. Design by Partsmith.
Free for personal and non-commercial use. If you share it, credit Partsmith by BakedBean3D and link this page. Selling prints or any other commercial use requires a paid plan (see the Terms).
Designed for FDM and exported at nominal size. Choosing a material changes the slicer advice we show - never the part's dimensions - so keep shrinkage compensation in your slicer's filament profile, where it's measured per spool. Clearance fits come from measured fastener and hardware tables. Snap and lipped parts assume a 0.4 mm nozzle; print 3+ perimeters for strength.