Loading…
Snap-in mount for a Sabrent HB-UMP3 USB hub, on a DIN rail, screwed to a panel, or stuck down with VHB tape.
Holds a Sabrent HB-UMP3 USB hub: it snaps in under four corner lips and lifts out again. Pick how the mount fixes to the printer: on a DIN rail with a printable clip, screwed to a panel (countersunk screws under the hub, fitted before it snaps in), or with VHB tape on its flat back. The hub-holding part is the Partsmith owner's own working design, published as drawn; the DIN and panel versions stand it on a light, windowed base that is thick only under the clips or screws and where the hub rests.
More on how these parts are made: the About page.
Designed for FDM and exported at nominal size. Choosing a material changes the slicer advice we show - never the part's dimensions - so keep shrinkage compensation in your slicer's filament profile, where it's measured per spool. Clearance fits come from measured fastener and hardware tables. Snap and lipped parts assume a 0.4 mm nozzle; print 3+ perimeters for strength.
Each configuration has its own page with recorded specifications and a link to the generator. Confirm your hardware revision before printing.
License: CC BY-NC 4.0. Design by Partsmith.
Free for personal and non-commercial use. If you share it, credit Partsmith by BakedBean3D and link this page. Selling prints or any other commercial use requires a paid plan (see the Terms).