Skip to content

Zip-tie Anchor

A zip-tie block that mounts to T-slot extrusion or a flat panel and keeps the screw and the tie on separate paths - the head is recessed, so it won't get in the way when you tighten the zip-tie.

Loading configurator…

About this model

A zip-tie anchor block for structure-mounted cable runs. The screw head is recessed and the tie routes above it through tunnels (two, or four for a cross layout), so tightening the screw won't mess up the tie and the tie shouldn't block a driver bit. Mounts to T-slot extrusion by default - a bolted T-slot nut, or a tool-free twist-lock foot on 2020-class extrusion and up - or to a flat panel with a screw. Tie width, thickness, and tunnel direction (parallel, perpendicular, or both) are all adjustable, with a minimum 1.2 mm wall on the base floor and bridge roofs.

Built for an easy print

  • Prints support-free in the orientation it downloads in - an automated gate checks every model on every change.
  • Meshes are verified watertight before they ship.

More on how these parts are made: the About page.

Key parameters

  • Tie width (mm) - default 4
  • Tie thickness (mm) - default 1.5
  • Tunnel orientation - default Parallel (along X)
  • Mounting interface - default T-slot nut + screw
  • Extrusion profile - default 2020 - Misumi spec (default; Voron 2.4/Trident)
  • Block height (mm) - default 8.5
  • Base width (X) (mm) - default 14
  • Base depth (Y) (mm) - default 12
  • Screw size - default M3
  • Material - default PETG

Print settings

Designed for FDM and exported at nominal size. Choosing a material changes the slicer advice we show - never the part's dimensions - so keep shrinkage compensation in your slicer's filament profile, where it's measured per spool. Clearance fits come from measured fastener and hardware tables. Snap and lipped parts assume a 0.4 mm nozzle; print 3+ perimeters for strength.

More in Cable Management

  • Cable Saddle Clip An open-top cradle that saddles a single cable or bundle (3-25 mm) and screws down with an M3 screw - into a T-nut in an extrusion slot, or a nut in a panel.
  • Extrusion Cable Raceway Open cable channel that screws to a 1515, 2020 or 3030 extrusion with two M3 slot nuts. Side exits, floor zip-tie tunnels and a snap-on lid; plain open walls also available. 40, 80 or 110 mm.
  • Structure-Mount Cable Clip (Snap-In C-Style) Snap a cable or hose (3-25 mm) into this C-clip from the top - no threading required. Twist-locks tool-free into 2020-class T-slot extrusion, or screw-mounts to a flat surface.
  • WAGO Connector Bank A labeled holder for a complete circuit of WAGO 221 lever connectors: 5V, 24V, 48V or 60V DC pairs, or AC L/N/G. For 3- or 5-port connectors, on adhesive tape or screwed to 1515, 2020 or 3030 extrusion.

All Cable Management

License and credits

License: CC BY-NC 4.0. Design by Partsmith.

Free for personal and non-commercial use. If you share it, credit Partsmith by BakedBean3D and link this page. Selling prints or any other commercial use requires a paid plan (see the Terms).