Loading…
A labeled holder for a complete circuit of WAGO 221 lever connectors: 5V, 24V, 48V or 60V DC pairs, or AC L/N/G. For 3- or 5-port connectors, on adhesive tape or screwed to 1515, 2020 or 3030 extrusion.
Holds two or three WAGO 221 lever connectors side by side as one circuit, with the circuit cut into a raised rear band so it reads from the front with the connectors in place. Pick the circuit (5V, 24V, 48V or 60V DC pair, or L/N/G), the connector size (3-port 221-413 or 5-port 221-415) and how it mounts: flat on adhesive or VHB tape, or on two M3 screws into 1515, 2020 or 3030 T-slot extrusion. It prints on its flat floor with no supports. Adapted from Michael Olson's Wago 221 angled clip mounts (Printables 570321 and 570322) under CC BY-SA 4.0; this model is shared under the same license. Not endorsed by the original author or by WAGO. The labels name the circuit you intend; check your own wiring before you power it.
More on how these parts are made: the About page.
Designed for FDM and exported at nominal size. Choosing a material changes the slicer advice we show - never the part's dimensions - so keep shrinkage compensation in your slicer's filament profile, where it's measured per spool. Clearance fits come from measured fastener and hardware tables. Snap and lipped parts assume a 0.4 mm nozzle; print 3+ perimeters for strength.
Each configuration has its own page with recorded specifications and a link to the generator. Confirm your hardware revision before printing.
License: CC BY-SA 4.0. Design by Partsmith, adapted from Michael Olson (M).
Shared under its source designs' license, which applies to this model instead of Partsmith's non-commercial terms. The download includes ATTRIBUTION.txt with these credits.
Modified by Partsmith: the holder and its retention catches were reworked, and two or three holders are joined into one labeled circuit bank on a flat adhesive floor or M3 screw seats for 1515, 2020 or 3030 extrusion.